Brainworx bx_digital V2 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
!
!
! ! ! ! ! ! ! ! ! ! !
Input, Output & Sidechain LEDs
These LED ́s show you the energy (level) of the respective channel (Mid Lo, Mid Hi or Side) going into that channel
and leaving that channel to be “bounced back to stereo” in the M/S Summing Amp stage of bx_XL V2.
The Input LED ́s can be adjusted / will be affected by the settings of the Master Input Gain, the Master Gain boost
knob and the individual channel ́s Gain boost slider. The Output LED ́s will be affected by the Master Threshold
knob, the individual channel ́s Threshold slider and the XL settings.
If you activate “Sidechain” in any channel this channel will display a third LED chain, the Sidechain meter. This LED
meter is a copy of the Sidechain meter in the Sidechain Mix window and represents the audio signal of the Sidechain
Mix. Use this meter to adjust your Threshold if Sidechain is active as the Sidechain audio signal can vary quite
radically from the internal audio of that channel.
Example: if you use the Mid audio signal in the sidechain to limit the Side channel the internal audio of the Side
channel will be much lower than the Mid audio signal. The Sidechain meters are the slim LED ́s between the regular
input and Output LED ́s.
- As the XL processor is post limiter in every channel the Output LED ́s can actually flash higher than the Threshold
slider needle. The slider indicates the level that will cause the limiter to cut off peaks but the XL processor added to
the limited signal may cause the signal of the respective channel to exceed the Threshold level. This is normal
behavior and intended.
- Any peaks exceeding the Threshold settings of individual channels (Mid Lo, Mid Hi or Side) will be stopped at the
final Peak Stop limiter stage.
Channel switches
Channel Active, Solo on/off, permanent Fader Link on/off, Sidechain active
Channel Active
All features (including the XL knob) of this channel will be bypassed when the LED is off.
A blue LED means the channel is active/on/working.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Comments to this Manuals

No comments